Emma Miller
The seams between bathroom and kitchen tiles are hard to reach with most detergents. These areas get dirty quickly, and they are not easy to clean if you don’t know certain secrets.
How to clean the joints between tiles in the bathroom with baking soda and vinegar – instructions
Soda and vinegar – household products that are in the cupboard of any housewife. With their help, you can easily clean even the most difficult places in the apartment – including the joints between tiles.
Technology is simple: mix baking soda and vinegar in equal proportions, and apply the slurry to the joints between tiles. Leave it for 5 minutes, and then, using a stiff brush, carefully rub the dirty places. Rinse off the solution with warm water and wipe the tiles dry with a rag.
How to clean tile joints quickly with baking soda
If you do not have vinegar at home, you can use baking soda alone – it also copes well with any dirt. You will only need a packet of baking soda and an old toothbrush. Then the procedure is as follows – you need to wet the seams with water and sprinkle them generously with baking soda. Wait 1-2 minutes, and then carefully rub with a toothbrush. It will not be superfluous to sprinkle a large brush with baking soda, and then clean the tiles with it, to remove all other dirt from the tiles. In the end, rinse everything off with warm water and wipe dry with a rag.
How to clean joints between tiles at home with bleach
You need to take any cleaner that contains a lot of chlorine – it “kills” not only bacteria but also fungus. The instructions for use of bleach are as simple as in the case of baking soda – moisten all the seams, apply the product, wait 10-15 minutes, thoroughly rub the seams, and then wash off with warm water.
How to clean the seams in the bathroom from yellowing with a homemade cleaner
Purchased household chemicals do not cope well with this kind of dirt, and why use them, if you can make the same remedy yourself? Mix in a container:
- water – 1.5 liters;
- baking soda – 150 gr;
- Vinegar – 100 ml;
- Citric acid 25 gr.
Spray the prepared solution on the seams through a sprayer and leave for 15 minutes. Then take a stiff brush and rub the tiles diligently with it. Repeat the procedure and then rinse with warm water.
